Hello all i am Gary, A newbie to posting but following the boards for 6 months.
I built the drycell 19 plate DIY kit from Greenfuelh20 configured +nnnnn-nnnnn+nnnnn-.
The system will go on a 2006 Toyota Tundra 4.7L. Right now I am just testing on the bench until I get it working the way I want. I ran it this weekend on jumper cables to the battery (truck running) with the following results.
2.0 volts across each 4X6 plate.
Amperage was between 26 and 28 amps.
3 qt reservoir temperature 85-90 degrees.
Cell temp 105 to 110 F.
Producing 1 ltr of HHO every 38 secs.
electrolyte mix was 4 tbls KOH to 1.5 qts of water.
Outdoor temperature here in north FL was in the high 60's.
Plates were media blasted, passivated in citric acid bath and run through Hyrogen Peroxide.
The bubbler is based on Ben's air stone build - 18 inches long, clear pvc with a 2in air stone.
From what I could tell this was the most consistent run I have had thus far. Now the question**
The amperage was never constant, it would start at 26 and run up to 28 amps and back down to 26 every 7 seconds. Are these normal readings? Gas production stayed constant at 1 ltr every 38 secs.
Thanks,
Gary