map sensor enhansor

[jchamp]

Hi guys I have poor wiring instructions on a duel map enhansor. I am not understanding if I just tie into my map sensor wires or am I bypassing it all together. I have 3 wires going into my map sensor a 12 amp a 5 amp and a ground. I know the 5amp is my sensor wire. But don't know to cut and tie into it or leave it in the sensor and splice onto it. If someone would set me on the right path. Thanks;

[nofearakis]

Hi jchamp,
you don't have amps but volts.
3 wires from your map:
1 ground
2 stable voltage
3 variable voltage, depends from your engines rpm.

No 3 wire is sendind voltage to ECU.
Cut this wire and connect your map potensiometer in series as the manual says.

[jchamp]

Thanks you are telling me to only cut the signal wire from the map sensor and on one end connect the red wire from the map enhancer and on the other end of the wire connect the green to to the map enhancer and the black wire to a ground.

[nofearakis]

Yeap!!!!!!!!!!