Has anyone used potassium carbonate as electrolyte? A friend told me to use it as it gives the same result and is more of an alkali, softer and far less abrasive!
I am currently using it and works fine!
I have replaced the o-ring type rubber gaskets with a laser cut head gasket material and the outside plates with 4mm stainless plates. I am presently using a 46 plate cell on a 10L diesel truck, hence the changes. I have had a fan on it to keep it cool, but found that it hardly ever gets warm too the touch! Currently running 4-5 l/min at 15-20amps and getting a 15 - 20% fuel improvement.
The Pot Carb help those that are worried about the gas going through the inter cooler! I also have found a proper dryer that I have installed just before the flash arrestor that will dry the gas properly before entering the air intake pipe.
Any remarks will be welcome, I am fairly new in the game and any suggestions will be welcome