Well I ended up with mixed results,the perferated plates seemed to produce more than the solid with low electrolight and low amps but once you get the electrolyte up to the norm and amps up over 10 amps they seemed to eqwal out and produce the same.sloid plates at 4.5 amps 13.8 volts water temp 70 f produced 1/8 lpm. Perferated plates at 4.5 amps 13.8 volts water temp 72 f produced 1/4 lpm, but once I put the amps to 13.5 at 13.8 volts water temp was 120 f and both produced 1/2 lpm. So I guess it's not going to help with my wet cell but I may try using solid plates for newtrel plates and perferated for + and- to see what happens or It may just be time to suck it up and build a dry cell to get my 1 lpm or as rusty had said to go with two seperate baths. I was also wondering about the hydrocarbon cracking system that hhofox was talking about,could you combine this with the hho unit having the hho output go through hcs system or have the hcs system output go through the hho system? Also has anyone tryed the hcs system and how safe is it? It seems scetchy to me no backfire arrester or water bubbler and heating gas vapor with the manifold. I'm just not sure of this but I like the idea of a more pure hydrogen if I used my cell with this I just may start to see some results. That would be nice.