http://brentnewton.deviantart.com/ar...tled-358213832
http://brentnewton.deviantart.com/ar...tled-358213953
http://brentnewton.deviantart.com/ar...tled-358213633
http://brentnewton.deviantart.com/ar...tled-358213832

So I just built this and I'm pulling way too much amperage. I just blew a 7.6a fuse, so I know its higher than 7a. Oh at 18v dc. My electrodes are 1/16" stainless steel sheets about 1 1/2" wide by 6" long. My electrolyte is salt. I made the mix in hot water so the resistance keeps going up. Last I read it, it was at 400 ohms.

I did this experiment last night with 19 gauge stainless steel wire and with only 12v it was working very well. Drawing only 1.5amps. Any suggestions?