Hi this is my first post on here so hello everyone ,

I have built my first dry cell it's 8 plates +nnnnnn- setup , plates are 6 inch 5 with gaskets they have 3 holes drilled in the top of each plate for hho to escape and one hole on the bottom for flow into the cell

It has 14 v into the cell but only drawing max of 5-6 amps ?

I have used up all my koh flakes now trying to get it to work via changing mixture but even with 500 g in 1 litre of water still the same ?

After about 30 mins the water was warm not hot but warm is that normal ?

I used a one litre bottle to test the output and it took about 2 mins to do 1/4 litre so not very good at all

The bottom of the feed tank / bubbler combined is about 2 inches above the top of the cell but I did try it a little higher but no change ,

There seems to be a gush of circulation once every few mins in between is just a bubble a second but the bubble is about the size do a 10 p in the pipe

Sorry for long post

Thanks