Originally Posted by
whear
1) What size should the SS plates be ? I suppose width is not a concern, since it will not be used in the electrolysis process. The thinner, the better ? ( for weight advantages, and some minor difference in the total size of the generator )
2) What spacing should I use between the plates ? I should get neoprene/rubber of this size, right ? If I understood correctly, the spacing between the plates is done by the gaskets only, right ?
3) What size should the 2 holes in the plates be ? ( for the electrolyte and the HHO production ) Also, the HHO coming out of the cell is accompanied by electrolyte, right ? Electrolyte enters from one hole and exits through the other, am I right ? In this case, the electrolyte valve is 1 way ( towards the cell ), and the HHO gas + electrolyte valve is also 1 way ( towards the reservoir ). I also suppose that the same applies to the reservoir holes. Please correct me if I'm wrong.
4) I'm building the cell for my 2001 Volkswagen Jetta 1.8 Turbo. I should aim for about 0.5 to 1.5 LPM, am I correct ?