Results 1 to 8 of 8

Thread: Bifilar Inductor ?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Aug 2014
    Posts
    12

    Bifilar Inductor ?

    Hello,

    I have searched the net for some discription on what a Bifilar inductor is but I have had no luck. Besides Wikipedia but its way too difficult to understand.

    What does the Bifilar inductor do ?

    Would it be needed when using 30 000 Volts but with around 0.7 Amps ?

    Many Thanks

  2. #2
    Join Date
    Aug 2014
    Location
    Planet Earth
    Posts
    51
    Can't imagine needing to use a BiFilar wound inductor/transformer for either producing or working with 30k volts.

    As for what bifilar is, it's essentially two wires wound as if they are one wire to form an inductor or transformer. Tesla would connect the two wires together in series. Other uses might be to use the two wires separately to transfer DC power from one end of the pair to the other. Since the wires are kept together, a fairly uniform capacitance exists between the wires along their entire length. The capacitance effect would be similar to a twisted pair or coax where uniform impedance is a concern.

  3. #3
    Join Date
    Aug 2014
    Posts
    12
    Hi,

    Okay. That answered my question, but I have another.

    I created a test cell replica of stanley meyer, 1.5mm gap between the tubes at each side. So a total clearence of 3mm.

    I connected it to a car battery and it produced a large amount of gas.

    So I wanted to test it using 30 000 volts using a automotive ignition system. So I connected the negative to the engine earth and the HT lead (one that goes to the spark plug) to the positive wire.

    Ok, spun the engine to about 2000rpm. Which equals to 500 pulses in one minute. Which also equals about 8 pulses per second.

    And I got NO production.

    I know there's a lot of power because a touch on the HT lead would give a nasty shock.

    Am I missing something or does it simply not work with high voltage?

    Or do I need to try a faster pluse ?

    Many thanks

  4. #4
    Join Date
    Aug 2014
    Location
    Planet Earth
    Posts
    51
    While this isn't a direct answer to your question, these links should provide some insight.

    http://www.hhoforums.com/showthread....tion-Water-has.

    http://www.hhoforums.com/showthread....ater-Fuel-Cell

  5. #5
    Join Date
    Aug 2014
    Posts
    12
    Hi,

    I have read through those threads but I could not find a good explination.

    I find it very puzzling that there is zero bubbles, not even a mist. But connected to a car battery it produces a large cloud...

    But I have some doubts on my rig so I am going to try and connect it to a better source. Maybe even a higher voltage

  6. #6
    Join Date
    Aug 2014
    Posts
    12
    Okay, I was doing a bit of research and found that instead of the voltage splitting the water, it is actually jumping to the next tube.

    So I am thinking, use 2 coils. One for the positive tube and one for the negative tube.
    But one coil sending a positive charge while the other coil sends out a negative charge.

    So there's no way that the voltage can disperse into the other tube. It will be forced to meet in the middle of the tube gap. Where it should split the water.

    Is it worth a shot?

    Thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •