Results 1 to 4 of 4

Thread: Odd problem

  1. #1
    Join Date
    Mar 2015
    Posts
    2

    Odd problem

    I made a 7 plate, 6x6 generator. It's runs great - but a very odd problem is cropping up:

    From a sealed container - the hho does not travel to the bubbler. It's as though the gas is staying in the container. The hose is a straight shot to the bubbler.

    The hho does not even want to fill a balloon right out of the container.

    Any ideas?

  2. #2
    Join Date
    Oct 2014
    Posts
    11
    Why do you think that it is working?

    If you're not seeing bubbles, it is not working at all.

    How much current is it drawing and at what voltage across the entire generator?

  3. #3
    Join Date
    Mar 2015
    Posts
    2
    I am seeing bubbles - quite a few in fact. After about 10 seconds the whole container is full of small bubbles. No foaming, no excessive heat, the HHO is not moving up the hose.

    I'm drawing 18 amps at 12 volts.

  4. #4
    Join Date
    Oct 2014
    Posts
    11
    Check for gas leaks. Spray soapy water around the cell. Only spray one electrical connection at a time. Rinse with distilled water or WD-40 before spraying the next one.

    Insure there is a passage from the interior through the outlet fitting.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •