Originally Posted by
BeaverRat
Hello,
I am designing a dry cell that will use 36 6"x6" plates, but I need a way to cut a 36"x36" plate into 36 6"x6" ones. I asked a local metal shop, but they wantet 85 dollars to do this... It seemed like a lot to me just to cut out 36 squares... What is the cheapest way to get these plates cut?
Thanks
Here $85.00 is cheap. They all charge $100.00 an hour shop time with a one hour minimum.
This is just my humble opinion. Let the pro's do it. If your plates are not very flat your effeciency will suffer. Even plates warped just a little are very hard on effeciency.
Larry
2008 Nissan Frontier 4X4 Nismo. 12 MPG baseline with my normal commute and heavy stop and go daily driving. Generator installed and working on 3/29/2009
Up to 14.5 MPG with no enhancers. Still testing the effects of lots of HHO and no electronic enhancers.